The Bottom Loading Method

The bottom loading method is a process where the installer removes the door seal or the entire door panel. The installer does not need to heat shrink the tint because the seal is out and allows the tint to lay flat, so this saves time on the install. After the window is thoroughly cleaned, the installer can install the window tint in one piece and slide it into place to fit the pattern of the window.

Similar to the 2 stage method, the installer squeegees the top section of the window, then rolls the window all the way up and pushes out all the soapy water with the squeegee. The benefit of bottom loading is that you can drop in the window tint without any obstructions like the seal (sweep). Any tight side gaskets can be easily bypassed because of all the room on the bottom of the seal, and the ability to press gently on the glass while sliding the window tint in.

• Greater Precision and Control 

Bottom loading provides greater precision and control during the installation process. It allows tinting professionals to carefully align the film along the bottom edge of the window before gradually smoothing it upwards. This precise approach results in a neater and more accurate application, ensuring that the film fits perfectly within the window frame. 

On the other hand, top loading may lead to potential misalignment and uneven edges. Bottom loading minimizes the need for rework, saving time and reducing the likelihood of errors. 

• Avoiding Peeling, Scratches and Damage 

When film is installed from the top down, it needs to be tucked below the window’s bottom seal, potentially causing scratches or damage to the film’s surface. As the film is tucked into the seal, it is not guaranteed to be below the seal and can catch when the window is operated. Bottom loading eliminates this risk, as the film is installed below the seal meaning it will never peel, preserving its integrity and appearance.